Pages

Mather and Platt Electric Mining Locomotive

This locomotive was another small electric locomotive built by Mather & Platt in the early twentieth century. The locomotive was intended for use in mines, though was standard gauge unlike many other mining locomotives. The locomotive was able to haul a load of 13 tons up a 1 in 33 incline. The locomotive had a fully enclosed motor on each axle.
The locomotive [1]



Information
Number built: 1
Built: 1904
Builder: Mather & Platt
Motor: Two electric motors (500v DC OHLE)
Formation: 4wWE

[1] J.F. Gairns, "Electric locomotives for mining, factory and allied uses", Electrical Age (August 1904) p. 94

Class 14 (BR Swindon 650hp Type 1 Diesel-Hydraulic)

The early days of BR dieselisation was littered with mistakes and sometimes outright lunacy, and the sad story of the Class 14 must rank as one of the worst. The Class 14s were built, at BR Swindon - the final locomotives built at the historic old works, as part of Western Region's experiments with diesel hydraulic transmission.
D9551 in yellow ochre livery at Kidderminster Town



However, the Class 14 was doomed from the start. Even as they were being built BR was already moving to standardise on diesel electric transmission and marking the WR diesel hydraulic fleet for early withdrawal. If that wasn't enough the work intended for these small Type 1 locomotives, trip working and inter-freight yard transfers, was quickly drying up [1] in the wake of the Beeching Report.

Information
Number built: 56
Built: 1964-65
Builder: BR Swindon
Engine: Paxman Ventura 6YJXL diesel
Power: 650 hp (485 kW)
Wheel arrangement: 0-6-0

BR began withdrawals of the Class 14 in 1968 as work dried up. Some were sent to work outside of Western Region such as at Hull but their lack of power and poor reliability did nothing to delay the inevitable [2]. All were gone by 1970, at most the locos had five years service for BR and most had far less than that.


Luckily, many were sold on to industrial users who eagerly snapped up these nearly new locomotives going cheap! Most of these locomotives went on to have good careers on private metals, with a number going abroad. Nineteen have been preserved, with many in running order.

One preserved Class 14 was even hired by BR's successor to work on the High Speed 1 route then under construction mainly shunting near London St Pancras. The Class 14s have been nicknamed the Teddy Bears.
D9500 at Darley Dale

D9539 at Rowsley South, this was the only livery they carried in BR service

D9551 at Bewdley, the yellow ochre was a "what might have been" livery

D9539 at Rowsley South

D9551 before it's repaint at Bridgnorth



[1] Brian Haresnape, Western Region Diesel Hydraulics (Ian Allan, 1982) p. 74
[2] John Jennison & Tony Sheffield, Diesel Hydraulics in the 1960s and 1970s (Ian Allan, 2004) p. 38

Class 97

Class 97 is the designation of locomotives used by British Rail (and it's successors) for departmental and special duties. Most locomotives which have been used for this purpose have been former revenue earning locomotives though some have been especially built. The only Class 97s currently in service are four Class 37s which were converted to test ERTMS radio signalling equipment. They are currently used mainly on the Cambrian Line from Shrewsbury to Aberystwyth which uses ERTMS.
97 303 at Derby


Information for 97/3
Number built: 4
Built: 1960-65 
Builder: English Electric (Modifed by Network Rail)
Motor: English Electric 12CSVT diesel
Power: 1, 750 hp (1, 305 kW)
Wheel arrangement: Co-Co

Other locomotives which have carried 97 XXX numbers include a quartet of Class 31s which were used to haul test trains for the Railway Technical Centre, one has been preserved and currently carries RTC livery. Class 25s, Class 45s and Class 46s were among the diesel classes also been used by BR for test purposes. One of the latter was 97 401 (46 009) which famously was destroyed by deliberately driving it into an empty nuclear flash to prove the integrity of the latter!

Class 97/6 were five 165 series shunters built by Ruston & Hornsby for departmental duties [1], unlike the mainline locomotives mentioned above, these were purpose built for departmental use. Numerous other shunters have also been transferred to the Class 97 fleet.
Former 97 654 now preserved at Peak Rail

Former 97 403 Ixion at Rowsley South

Side view of 97 303

97 205 at Princes Risborough

97 303 pulls away with a test train



[1] Colin J Marsden, Departmental Stock (Ian Allan, 1984) p. 108

Mather and Platt Electric Locomotive for Sweden

This locomotive was built by Mather & Platt of Manchester for industrial use in Sweden at an iron works. The locomotive had a very similar cab to the locomotives built by Mather & Platt for the City & South London Railway (the first London "tube"). It was also powered by Hopkinson electric motors of the double armature type with a spur gearing to allow for very slow speeds. The locomotive could haul up to seventy tons.
Photo of the locomotive [1]

Information
Number built: 1
Built: 1890
Builder: Mather & Platt
Motor: 2 Edison-Hopkinson traction motors
(300-330v DC third rail)
Wheel arrangement: 4wWE

Preserved CSLR locomotive at the LT Museum, notice the similar body and cab design


[1] J.F. Gairns, "Electric locomotives for mining, factory and allied uses", Electrical Age (August 1904) p. 93